On most models it will be housed in a small box made of gray or black plastic.
Top loading washing machine door will not lock.
Child lock also will lock the door on some models like front loaders.
Whirlpool top loader with locked door.
Look for the lid lock switch on the underside of the top panel and where it fits into the appliance.
Check the lid switch and striker.
Make sure it s not out of alignment.
If the door lock is damaged or does not latch properly.
Normally waiting for the cycle to end is all you need to do to unlock the door or turn your washer on if it s off.
The door strike also known as the catch or hook is part of a safety mechanism installed on front loading washing machines or used to activate the lid switch on a top load washer.
Itis also equipped with active waterjeta built in faucet that lets you pretreat stained clothes with a press of a button and an ez access tub design that allows you to easily reach the bottom of the.
This is the electronic mechanism that actually controls the washer s locking function.
Put the lid back down and plug the washing machine back into the electrical outlet.
Once the water is gone the door will unlock.
If not call for service.
The striker is the part that helps press down the lid switch.
Capacity to help you fit more in every load and cut down on laundry time leaving more time for you.
The door lock can fail either mechanically or electrically.
Place a magnet between the two so there is a magnetic connection between the lid lock and the solenoid inside the washer.
Reconnect power to washer plug in.
If the door lock is defective the washer door will not latch properly.
Wait approximately 2 minutes for control to reset.
Front loading washers include a control lock feature that temporarily disables use of the control panel and requires deactivating the lock prior.
The door should unlock after this is complete.
The door lock secures the washer door shut during operation.
Identify the lid lock switch on the underside of the top panel.
If the door hook becomes damaged it may not properly activate the door lock assembly or.
Turn on the appliance and lift the.
If you have a whirlpool top loader and the door is locked with a flashing light here are some things you ll need to check.
Inspect the door lock for damage.
Once the washer door is closed the washer can begin operating.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
On front load washers the door hook is used to engage the lock mechanism.
Chances are this little widget is responsible for the issue you re experiencing.
If you get stuck though you can drain the water from front load washers using the emergency drain hose.
