Tools Needed To Pull Up Carpet

Pull up the edge of the carpet near any wall.

Tools needed to pull up carpet.

7 use a utility knife or carpet knife to slice the carpet into manageable strips and roll the strips up as you go. Keep both hands on the knife to avoid cutting a free hand. By driving screws into the floor joists. Roll or fold the strip secure with duct tape and remove it from the room.

Walk around the room pencil in hand and mark squeaky spots. Heavy duty staple remover. Pry bar and hammer. Leave transitions for the installer.

Use measuring tape to determine proper width image 1 then use a carpet blade to cut the carpet into 4 foot wide strips image 2. Eye protection and dust masks. Footstool and or knee pads. If the goal is simply to get the old carpet out of the way protect your hands with heavy gloves and use a sharp utility knife to cut a border around the entire area about four or five inches away from the walls.

Use a utility knife with a sharp new blade to cut through the carpet backing. Heavy duty trash bags. Carpet pullers are what the professionals use to pull up large carpets all at once. However it s not easy to roll transport and dispose of such a large carpet roll for example a 10 10 room would result in a 10 long section of carpet rolled.

Tools needed to remove carpet 1. Drive screws through loose flooring and into joists to stop squeaks. How to replace carpet. It s fairly easy to pull up an entire room of carpet in one section.

With a bare floor you can eliminate floor squeaks the easiest most effective way. Pull up a few feet of carpet and fold it over. Heavy duty utility knife. The clamp is very strong and it is simple to get a grip on the handle so that you can pull with all of your might.

Fold the carpet over for easy cutting and slice it into narrow strips. Pull back and roll up strips pull up each 4 foot strip loosening it from the remaining carpet image 1. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. In order to remove carpet easily and efficiently it s best to cut the carpet into 4 foot wide strips.

Existing nails or screws tell you where the joists are. It is really simple to use as it just clamps onto the carpet and you pull it up. Pull cut and roll. Pulling up carpet depends on the reason the carpet needs to be pulled up.

Roll up the strips and tape them for easy handling.