Level the toilet base then tighten the bolts and cap them.
Tools needed to install a new toilet.
After the toilet is installed cut the excess shims with a knife.
If the flange is ok remove the rag from the hole and take the closet bolts out of the flange.
Use the shims to stabilize the toilet and tape in place.
If the flange is damaged get help from a plumber.
Use a deep seat wax seal when replacing older water toilets.
Finally adjust the chain to the right length turn the water back on and flush the toilet to make sure it flushes immediately and refills within 45 seconds.
Unbolt the old seat then pop the new one in place using the hardware included in your new toilet seat s box.
Installing a new toilet seat is an easy diy project.
Whether you re replacing yours because it s old or because you just want a new style all you need are some basic tools and a few minutes.
If you re buying a new toilet you need to know the rough in measurement of the old one.
If your old toilet was rocking while in place you can help stabilize it with toilet shims.
Fit a new seal around the drain hole in the floor and make sure it s tight.
Remove the bowl and continue the installation with the wax ring.
To install them set the toilet in place without the wax ring.
For the vast majority of toilets the waste.
Leaving it in is a common and costly.
Slide the cone washer onto the tailpiece of the new flush valve the beveled side of the cone washer should point toward the end of the tailpiece.
Squeeze enough wax onto the bolts to hold them upright.
So gather up your new toilet replacement wax ring rubber gloves hacksaw a putty knife adjustable wrenches plunger a bucket and some old rags.
Remove the rag before installing the new wax seal.
Install a new flush valve unscrew the spud nut with a spud wrench or a pair of slip joint pliers and remove the old flush valve.
If you know how to replace a toilet seat you can make a cosmetic improvement to your bathroom in just a few minutes.
Replacing or installing a new toilet isn t as hard as it may sound.
Replacing a toilet seat.
Whether you re installing a better flushing toilet or resetting the old one after remodeling these tips will help you do it faster and with fewer problems.
Install the new wax seal and hook the new closet bolts into their slots on the flange image 2.
After that you ll need to connect the new flapper by sliding the holes on the rubber seal over the pegs and reattaching the lift chain.
Seats get damaged or cracked but most often the goal is to simply freshen up the look of the toilet.
Then lift the toilet onto the floor bolts and jiggle it a bit to seal the drainage hole.
Place the new toilet bolts in the flange with the bolts pointing up.
To install a new toilet first turn off the water supply and remove the old toilet.
