Instructions check the bolts first.
Toilet not secured to floor.
If this is the case it wont matter if the toilet bolts are tight or not.
Your wobbly toilet may be moving because the mounting bolts that hold it down have nothing to grab onto anymore.
We would place the toilet pan on the floor and mark out the foot print with a pencil and the remove it again the next step would be to cut a hole in the floor under the pan for a key this would create a lock between the pan and the floor.
The wax ring is the weakest component of the elements involved to mount the toilet to the drain and floor.
While this is true you should know that the bolts don t go directly to the floor.
Diyers often set the toilet and then apply a tiny bead of caulk along the outside edge.
Sometimes a rocking toilet can be fixed by tightening the two bolts at the base of the toilet.
13 set toilet back into place.
Examine the base of the.
17 check to make sure toilet is tight to floor and doesn t rock.
Check carefully for water around the.
Rotted closet bolts why its important to use good brass closet bolts they will not rot out like this.
16 install bolt caps over the closet bolts.
Instead they secure to a toilet flange.
Another thing it could be is the toilet flange not being secured to the floor.
A damaged leaky wax ring is often the culprit in a leak from underneath the toilet.
The wax seal is placed over the toilet horn when the toilet is being installed.
14 tighten nuts on closet bolts.
That doesn t always provide a good enough bond to the floor and it leaves a prominent caulk line.
Press down to compress gasket.
If a proper seal is not achieved it will result in leaking.
Any play in the piping will be evidenced at the toilet itself.
There s an easier way to secure the toilet and provide a cleaner caulk line.
If the flange is lower than or flush with the floor they make foam rings that cover the distance for a proper seal.
Start the repair by confirming that your toilet is not leaking.
You might think your loose toilet bowl is held down to the floor by a couple bolts.
The final step would be to mix up a stiff mix of mortar and place a large amount of this inside the under neath of the toilet pan and also a mound on the floor.
