Use a scraper to remove the old wax ring from the floor and toilet as well as disinfectant to clean around the area.
Toilet bowl on the floor.
Disconnect the toilet step 4.
Remove lift and set the toilet on the floor upside down or on its side.
You also want to make sure the toilet sits level and does not rock on the floor as this can compromise the seal.
Install the wax ring and lower the toilet onto the flange.
Instructions check the bolts first.
Turn off your home s water supply and begin emptying the water from the toilet bowl and the tank.
Screwdriver sets step 1.
Remove the toilet and turn it on its side.
Start the repair by confirming that your toilet is not leaking.
Then make an outline of the toilet on the floor with masking tape.
Sometimes a rocking toilet can be fixed by tightening the two bolts at the base of the toilet.
Lay a tarp or newspaper down to protect your floors.
Remove and replace the wax ring step 5.
Examine the base of the.
Water on the floor or a running toilet could signal the need for a minor repair a major one or even a new toilet and a few simple tests can help you decide which it is.
You will need to do this by loosing the bolt.
Flush the toilet to drain as much as possible and use rags to sop up any water that remains.
You might think your loose toilet bowl is held down to the floor by a couple bolts.
Carefully lift the tank off the bowl and place out of the immediate area then remove the nuts from the floor bolts.
Hold the toilet upright over the flange and guide the bolts through the holes in the base as you lower it in place.
Disconnect the water supply line with an appropriate sized wrench.
Gather tools and materials step 2.
Remove the nuts from the mounting bolts that hold the tank onto the bowl with a wrench.
Unscrew the water line from the tank.
Check carefully for water around the.
Measure the depth and width of the gluing edge of the bowl.
While this is true you should know that the bolts don t go directly to the floor.
Your wobbly toilet may be moving because the mounting bolts that hold it down have nothing to grab onto anymore.
Undo the t bolts and lift the toilet off the floor.
Next move your caulk gun to the inset depth you just measured and apply caulk directly to the floor maintaining the inset depth as you follow the tape.
There should be one on each side.
Check the connection bolts and tighten or replace step 3.
The location of the.